Corrosion Shield - 20L (5 US Gal)

S2S Corrosion Shield polar bonds to metal like a magnet to steel, displacing water and oxygen and leaving an even, lubricating film that creeps into hard-to-reach areas. It delivers long-lasting protection and excellent anti-seize performance on everything from wellheads and flanges to motors, batteries and machined surfaces.

Key advantages

• 500+ hours without corrosion in ASTM B117-18 salt spray testing
• Prevents rust and corrosion for up to 3 years
• Rubber compatible to ASTM D471 standards
• Dielectric strength of 36,000 volts
• Can be applied over existing rust and paint, and to damp surfaces
• Self-healing; stops rust on contact
• Removes easily with high pH detergent
• Ultra low VOCs and zinc-free
• Non-hazardous and easy to use

Recommended uses

• Wellheads, pipelines and piping
• Fittings, flanges and valves
• Electrical, electronics and batteries
• Offshore rigs and cranes
• Motors, machined surfaces and sculptures

Application

Apply to rusted, painted, damp or bare metal — no sandblasting needed. Remove debris, soap and degreaser first; a wire brush can be used to take off loose corrosion. Paint topcoats over Corrosion Shield are not recommended. For best results apply when surface temperatures are between 41°F and 99°F (5°C – 37°C).

This item

Single 20 L (5 US gallon) pail. Supplied by Citimarine Store, part of the S2S Corrosion Solutions range from Valkyrie. Reference CO-CORS-005.