By buying this product you can collect up to 25 Citimarine points. Your cart will total 25 points that will be converted into a voucher of $2.50 towards your next purchase! Must be logged in to collect points.
Corrosion Shield - Aerosol Can 340g, 12oz (Box of 12)
S2S Corrosion Shield — 340 g (12 oz) aerosol, box of 12. S2S Corrosion Shield polar bonds to metal like a magnet to steel, displacing water and oxygen and leaving an even, lubricating film that creeps into hard-to-reach areas.
S2S Corrosion Shield polar bonds to metal like a magnet to steel, displacing water and oxygen and leaving an even, lubricating film that creeps into hard-to-reach areas. It delivers long-lasting protection and excellent anti-seize performance on everything from wellheads and flanges to motors, batteries and machined surfaces.
Key advantages
- 500+ hours without corrosion in ASTM B117-18 salt spray testing
- Prevents rust and corrosion for up to 3 years
- Rubber compatible to ASTM D471 standards
- Dielectric strength of 36,000 volts
- Can be applied over existing rust and paint, and to damp surfaces
- Self-healing; stops rust on contact
- Removes easily with high pH detergent
- Ultra low VOCs and zinc-free
- Non-hazardous and easy to use
Recommended uses
- Wellheads, pipelines and piping
- Fittings, flanges and valves
- Electrical, electronics and batteries
- Offshore rigs and cranes
- Motors, machined surfaces and sculptures
Application
Apply to rusted, painted, damp or bare metal — no sandblasting needed. Remove debris, soap and degreaser first; a wire brush can be used to take off loose corrosion. Paint topcoats over Corrosion Shield are not recommended. For best results apply when surface temperatures are between 41°F and 99°F (5°C – 37°C).
This item
Box of 12 aerosol cans, 340 g (12 oz) each. Supplied by Citimarine Store, part of the S2S Corrosion Solutions range from Valkyrie. Reference CO-CORS-012-B012.