By buying this product you can collect up to 18 Citimarine points. Your cart will total 18 points that will be converted into a voucher of $1.80 towards your next purchase! Must be logged in to collect points.
NMEA 2000 Alarm Button - YDAB-01
Yacht Devices NMEA 2000 Alarm Button - YDAB-01 - The Alarm Button is a multifunctional NMEA 2000 device with wires for connection of an external button with an LED indicator and a standard 4 or 8 Ohm sound speaker. It contains a 10W audio amplifier inside and a bank with 28 sound signals (car anti-theft alarm, ship horns, whistles, tone signals, etc.).
Part Number: YDAB-01N
Yacht Devices NMEA 2000 Alarm Button YDAB-01
The Alarm Button is a multifunctional NMEA 2000 device with wires for connection of an external button with an LED indicator and a standard 4 or 8 Ohm sound speaker. It contains a 10W audio amplifier inside and a bank with 28 sound signals (car anti-theft alarm, ship horns, whistles, tone signals, etc.).
The Alarm Button can be configured for the following:
- MOB button (default mode).Pressing the connected button for two seconds sounds an alarm and sends AIS MOB messages (emulating the message received from EPIRB and SART devices with AIS VHF support) with the current GPS position. It sets the mark of MOB position on a chart plotter. Pressing the button a second time cancels transmission of MOB messages. Note that messages sent from the Device are not transmitted externally via VHF or AIS, but are available to all NMEA 2000 devices on the vessel.
- Digital switching alarm unit. The device acts as an NMEA 2000 binary switch bank with 28 channels, each channel has a unique sound alarm and LED flashing sequence. Channels (and corresponding sound alarms) can be turned on/off from other equipment, including our smart sensors or from the screen of a modern chart plotter. The button connected to the device cancels the alarm.
- Engine monitoring unit. In this mode, the Device produces sound alarms according to engine alarms sent by the engine control unit or gateway to NMEA 2000. This mode is useful on boats where the regular engine monitoring instruments are already in need of replacement. The Device can also be programmed to produce a sound alarm itself at a specified temperature, engine revolution reading, etc.
This device works for you if:
- You have no MFD in the cockpit, and you need to set the MOB mark and wake up your crew fast;
- Your MFD has no hardware MOB button required by racing rules;
- You need the sound alarm managed from a button or from an MFD screen, to call your backup crew in windy and noisy weather;
- You need to monitor engine parameters and warn helmsmen that parameters are above or below normal (particularly for rented boats);
- You need to sound alarms from sensors or other devices.