Unsurpassed Quality & Reliability
BOLLARD™ Generators are designed and built in the USA specifically for the rugged conditions of commercial use. The expected time between overhauls on the BOLLARD™ packaged generator set is 40 to 50 thousand hours.
Heavy Duty windings engineered for 80°C rise of 40°C ambient yield extended insulation service life, high electrical efficiency for maximum fuel economy, and superior motor starting at all voltages. PMG dedicated excitation is standard, resulting in even higher motor starting together with 300% sustained short circuit capacity along with VFD and paralleling compatibility.
EmissionsThe Bollard MG50 –MG 395 Gen-Sets are EPA certified Tier 3 Marine, CARB, EU, and MOC. They meet the lowest emissions levels available on the market today without
exhaust after-treatment resulting in reduced maintenance and operating costs while preserving our clean air and water quality.
Keel Cooling, Heat Exchange, or Radiator Compatibility Premium Marine Grade Protection
Bollard generators feature Imron™ 2 part marine epoxy overcoats on the engine, generator, and base frame. Accessory brackets are typically powder coated, and fasteners are primarily stainless steel to protect your investment from the harsh marine environment.
Heavy Duty Structural Steel Base Frame & Reduced Noise
For ease of installation, added structural integrity, safety and durability. Superior vibration and noise dampening with a high mass flywheel, polyurethane vibration isolators, mass loaded & stiffened base frame, and de-noised engine.
Heavy Duty Air Intake Filtration & Silencing
For increased performance, extended engine life, and quiet operation.
Controls, Gauges, & Instrumentation
Standard enclosed prewired J1939 digital control panel with key start/stop and run/idle switch. Safety shutdowns are programmed for high water temp, low oil pressure, and over-speed. Included are LED readout of all J1939 trouble codes and diagnostics. Custom panels offer, auto-start/stop function for inverter or paralleling interface, load sharing, digital generator output LEDs and full function electrical distribution switchboards.
Optional SEADRIVE™ Front Power Take Off System
Compact heavy duty housing, pre-aligned, easy to install, service friendly, integrated torsional coupling, and available with or without a clutch.
|Engine Type||In-Line | 6 Cylinder | Diesel|
|Displacement - L (cu.in)||9.0 (549.21)|
|Bore x Stroke - mm (in)||118 (4.65) x 136 (5.35)|
|Aspiration||Turbocharged - Seawater Aftercooled|
|Oil Sump Capacity - qts (L)||32.75 (31)|
|Emission Regulation||EPA Commercial Marine Tier 3|
|Prime - 60hz, 1800RPM (HP)||260kW (373)|
|Standby - 60hz, 1800RPM(HP)||287kW (410|
|Motor Starting Range - HP||39.75 - 54.1|
|Voltage Regulation||+/- .25%|
|Starter||24v | 4.5kW|
|Alternator||24v | 75 Amp|
|Operating Angle - Degrees||12° (Constant) | 30° (Intermittent)|
|Dry Weight - lbs||4973 (engine, 433 gen, skid)|
|Length x Width x Height - in||(See brochure for details)|