By buying this product you can collect up to 873 Citimarine points. Your cart will total 873 points that will be converted into a voucher of $87.30 towards your next purchase! Must be logged in to collect points.
Spectra Watermakers Ventura 200T Watermaker with Analog Control Panel - VT-200-T-12V
The Ventura 200T is the same size and configuration as the Ventura 150, but uses a higher displacement Clark Pump to produce more water. This allows it to operate in warm waters above 50F (10C), delivering over 8 gallons (31 liters) per hour. With it’s modular design, it’s an ideal system for installation in tight spaces whether you’re cruising, fishing, or racing. Simple analog controls and gauges display the feed water pressure and the product flow meter. A hand-held salinity monitor and a three-way valve for product water testing are included.
Reference: VT-200-T
$8,160.00
Free Shipping on Orders over $99
*On Orders Over $99; Not including: Hazardous, Oversize, Greater than (+150 lbs.) or Freight Advertised Products. FEDEX Ground Shipping / Continental US Only
Shipping Calculator
Package Includes:
- High Pressure Clark Pump and Reverse Osmosis Membrane Module
- Analog Gauge Assembly
- Inlet Feed Pump Module with Fresh Water Flush System
- Accumulator Tank
- Manual
- Installation Fittings Kit
- 5/8" Hose (2 x 25')
- Service Kit
Features:
- Spectra 200T Ventura Desalinator includes installation kit with handheld salinity meter and a water sampling valve
- Designed for warm water above 50 degrees F (10 C)
- Commercial-grade diaphragm pumps with run-dry protection
- Low power consumption; can be run on batteries, solar or wind power
- Whisper quiet
- Compatible with Spectra's Z±Ion system (sold separately)
- Protects membrane, filters on your Spectra watermaker
- Specifications:
- Fresh water production:
- 8.3 Gallons (31 liters) per hour
- 200 Gallons (757 liters) per day
- Po10A @ 12V DC
- Power Consumption:
- 14.5W per gallon
- 4W per liter
- Pre Filters:
- 2.5"x10 " pleated polyester 5 micron
- 2.5"x10 " pleated polyester 20 micron
- Controls: Analog controls
- Installation requirements: Dedicated thru hull (sold separately), dry and well ventilated area not to exceed 110 F / 37C
- Membranes: 20" x 2.5" High rejection spiral wound polyamide
- Pump and Motor: Shurflo diaphragm pump
- Salt Rejection: 99.2 %
- Temperature range:
- Maximum 110 degrees F / 37 degrees C
- Minimum 36 degrees F / 2 degrees C
- Baseline conditions: 33,000 PPM feed water at 77 degrees F / 25 degrees C
- pH Range: 3-11 (typical seawater pH is 8)
- Chlorine Tolerance: 0 PPM
Warranty: Spectra standard warranty
Note: The system must be connected to a dedicated 1/2" to 3/4" forward facing scoop type intake, thru-hull and seacock. A brine discharge thru-hull should be above the waterline, along or just above the boot stripe, to minimize water lift and back pressure. (Thru-hulls sold separately)
